Haklift Oy
Asessorinkatu 3-7
20780 Kaarina, Finland
Tel. +358 2 511 5511
www.haklift.com
Lifting Solutions Group
Axel Johnson International
5
.
Operation manual
5.1 Before operation of the hand pallet truck, please make sure
that the cargo weight does not exceed the rated load.
5.2 The cargo loading type is shown in fig. 6.
5.3 See fig. 5, when the control handle knob (10) is placed to
“lift
position
”, the truck will be in a lift state. At this time, if you rock
the handle, the truck forks will lift.
5.4 See fig. 5, when the control handle knob (10) is placed to
“free position”, the truck will be at travel mode. At this time, if you
rock the handle, the truck will neither lift or lower. You can use
the truck to move the cargo.
5.5 See fig. 5, when the control handle knob (10) is placed to
“drop position”, the truck forks will lower automatically. Be careful
when lowering the load! See also item 13.2 related.
6
.
Points for attention and safety norms
6.1 Operators must wear suitable work clothes, safety shoes and gloves when operating the hand pallet truck.
6.2 When hand pallet trucks are transported by/in a truck, they should be locked/secured in place in order to
prevent the pallet trucks from moving.
6.3 When the pallet truck is used for motor vehicle loading, the truck must be moved slowly to ensure safety.
6.4 Wheels, bearings and bushings of the truck are wearing parts. Please change them according to need.
6.5 Do not park the hand pallet truck on a slope or in emergency passages.
6.6 When the hand pallet truck is used on a slope, the operator should operate the pallet truck carefully to
ensure safety, and the operator should be on the top side of the slope. It is forbidden to make turns on a slope.
6.7 It is forbidden to stop the pallet truck on a slope.
6.8 When the hand pallet truck is not in use, the forks should be lowered to the lowest position.
6.9 Do not park the truck at places where it will block the traffic or it is inconvenient for work.
6.10 Do not use the truck in rainy environment.
6.11 It is forbidden for the operator to sit or stand on the hand pallet truck (to operate the truck).
6.12 Hand pallet truck is suitable for use on hard, flat, clean/dry and unobstructed ground/platform. Beware of
little rocks or similar which could lead to a wheel breakage, especially if a loaded pallet truck is steered over
such impurities.
6.13 Do not pile the cargo too high in order to prevent the goods from falling down or overturning of the truck.
6.14 Do not use the hand pallet truck to carry or lift people.
6.15 Untrained personnel are not allowed to stand around the operation area in order to avoid injury caused
by sudden malfunction.
6.16 Before the hand pallet truck is pushed into an elevator, the operator should make sure that the elevator
can bear the total load of the hand pallet truck and the cargo as well as the total weight of the operator and
other personnel in the elevator. When entering the elevator, people should let the load enter first but not the
operator. When the load or hand pallet truck enters or leaves the elevator, other personnel should not stay in
the elevator.
6.17 Hand pallet truck should be stored in dry and ventilated environment.
6.18 When the cargo weight exceeds 2500 kg (allowed for specific models), please operate the truck by two
persons together for labor-saving.
6.19 Hand pallet truck shall be assembled, adjusted, used and serviced by competent personnel with the
necessary technical skills and understanding.