Hakko Electronics Monitouch V9 Series, Руководство по подключению

Страница: 73 / 430

1.5 System Device Memory for Communication Confirmation
1-61
$Pn: 356 to 451
This device memory is valid when an Omron ID controller (V600/620/680) is connected with [Guarantee synchronism of the
data] checked on the [Device Memory Map Setting] dialog.
 Status ($Pn 356, 359, …)
The execution status of the device memory map is stored here.
The bit is set (ON) when reading or writing of the first data in the device memory map is correctly finished.
When the control device memory (command bit) is set (ON), the bit is reset.

Error code 1 ($Pn 357, 360, …)
An error code is stored when an error occurs in the reading or writing of data in the device memory map.
If multiple errors occur in the device memory map, the last error code is stored.
When the control device memory (command bit) is set (ON), the bit is reset.
Errors other than the above are stored as shown below.

Error code 2 ($Pn 358, 361, …)
The exit code is stored here when “800BH” of error code 1 is stored.
Code (HEX) Contents
FFFFH Time-out
8001H Check code error
8002H Data error
800BH Receives the error code from the connected device
Exit Code (HEX) Contents
10
Host communication error
Parity error
11 Framing error
12 Overrun error
13 FCS error
14 Format error, execution status error
18 Frame length error
70
Slave communication error
Tag communication error
71 Inconsistency error
72 Tag absence error
76 Copy error
7A Address error
7C Antenna disconnection error
7D Write protect error
75
Tag device memory
warning
Data check command
Exit code stored when the writing count management command has been
successfully processed (without any error)
76
Data check command
Exit code stored when the writing count management command has abnormally
been processed (comparison error, excessive writing counts)
92
System error
Abnormal mains voltage at antenna
93 Internal device memory error
1: ID tag recognized
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
0 0 0 0 0 0 0 0 0 0 0 0 0 1 0 0
System reserve
Buffer-full error
Parity error
Overrun error
Framing error
Break detection
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
0 0 0 0 0 0 0 0 0 0
MSB LSB
Error
0: Bits 0 to 14 are all “0”.
1: Any bit from 0 to 14 is other than “0”.