![background image](http://html1.mh-extra.com/html/hakko-electronics/fr-4104/fr-4104_instruction-manual_3332316005.webp)
3
B. HAKKO FR-4104
●
Attach the filter pipe
Insert the filter pipe (with a filter holder, spring filter and ceramic paper filter (L))
into the housing. Push and turn the back holder clockwise.
4. INITIAL SETUP
Back holder knob
Filter pipe
Handpiece
holder base
●
Insert the cleaning sponge
The sponge is compressed. It will swell when moistened
with water. Before using the unit, dampen the sponge with
water and squeeze it to remove excess water.
CAUTION
Increasing the angle of the handpiece receptacle will cause
an increase in the handpiece temperature.
CAUTION
Be sure the sponge is moistened with water before use to avoid damaging the nozzle.
NOTE :
You can put nozzles that are not in use on the radial tray
of the handpiece holder base.
Loosen the adjusting screws to change the angle of the handpiece
receptacle as you like, then tighten the screws.
A. Handpiece holder
●
Setup the handpiece holder
Following the instructions given in the illustration on the right,
assemble the handpiece holder.
1. Fit the small sponge pieces into the hollows in the
handpiece holder base.
2. Add an appropriate amount of water into the handpiece
holder base. The small sponge pieces will absorb water
and help keep the larger sponge damp at all times.
3. Dampen the large sponge, squeeze it to remove excess
water and put it on the handpiece holder base.
Radial tray
Cleaning
sponge
(Large)
(Small)
4
Turn the power
switch ON.
Connect the hose.
CAUTION
Be sure to hold the plug when inserting or removing the handpiece cord.
C. Station
●
Connection
1. Connect the power cord to the receptacle on the
rear of the station.
2. Connect the plug from the HAKKO FR-4104
to the receptacle on the HAKKO FR-410.
CAUTION
Connect the plug to the receptacle, aligning the tab
on the plug with the opening on the receptacle.
3. Set the HAKKO FR-4102 in the handpiece holder.
4. Connect the hose from the HAKKO FR-4104
to the vacuum outlet cap on the HAKKO
FR-410 station.
5. Plug the power cord into a grounded power outlet.
Ensure that the power switch is OFF before plugging
in the power cord.
CAUTION
Be sure to ground this product as it is ESD
safe by design.
6. Turn the power switch ON.
Insert the plug into
the receptacle until
it seats.
To disconnect, pull the plug
from the receptacle while
pressing down the tab on
the plug.
5. OPERATION
PART NAMES
Control
Buttons
Receptacle
Power Switch
- Moving the cursor UP. Increases the value.
- Moving the cursor DOWN.
Decreases the value.
- End of sequence (terminates a phase
of a data entry mode).
UP
DOWN
ENTER
The HAKKO FR-410 has three controls
Vacuum
outlet cap
F
Normal display screen
Содержание FR-4104
Страница 32: ...11 PARTS LIST 31 Pump assembly 23 21 24 22...
Страница 35: ...12 WIRING DIAGRAM 34 Inlet Power switch...