EN
PROFESSIONAL CORDLESS CLIPPERS
23
3.4.
Using the comb attachments
The clippers must be switched off. Select a comb attachment
(Fig. 1 refs. E-J).
Place the comb attachment on the blades and clip in at the rear. When the comb
attachment is correctly fixed, it is immobilized.
3.5.
Replacing blades
Switch the clippers off and unplug the unit from the mains power supply.
Take the screws out of the blades (Fig. 4) and remove the upper and lower
cutters.
During their assembly, the upper and lower cutters must be aligned as instructed
below:
Set the adjusting lever to the minimum cutting height.
The distance between the front edge of the lower cutter and the front edge of
the upper cutter must be between 0.8 mm and 1.5 mm.
The upper and lower cutters must be set parallel.
The end tooth on the upper cutter (on the left-hand end) must cover the end
tooth on the lower cutter.
The other end tooth on the upper cutter (on the right-hand end) must also touch
the corresponding end tooth on the lower cutter (on the right-hand end).
Tighten the two screws (Fig. 4).
