MANDO Adapt T812
Installation
Order h49 7144.907-333
43
4. Screw in the fixing screw on the adaptation ring and
tighten it to the specified tightening torque [see »Screw
tightening torques« chapter].
5. Check face run-out on the test surface of the adaptation
ring [ideally ≤ 0.005 mm].
Whenever the face run-out is greater than the maximum per-
mitted value:
6. Remove the adaptation ring.
7. Clean the locating face and the mating faces of the basic
clamping device and the adaptation ring.
8. If there is a burr or slight damage to the locating face of
the basic clamping device and the adaptation ring, rub it
down gently with an oil stone.
9. Reinstall the adaptation ring.
10. Repeat the alignment process.
11. Repeat the face run-out test.