MANDO Adapt T212
Faults
104
Order h49 7144.907-333
Fault
Possible cause
Remedial action
Remedied by
be swapped in or
out
Adaptation clamp-
ing device not un-
locked
Unlock the adaptation clamping
device manually [see »Unlocking
the adaptation clamping device
manually« chapter]
Skilled special-
ist
The coupling slid-
ers do not move
automatically
Clean the adaptation clamping de-
vice
Skilled special-
ist
Clamping force is
too weak
Workpiece outside
the clamping width
diameter
Use a suitable clamping element
Skilled special-
ist
Axial actuation
force is too weak
Check machine setting and cor-
rect if necessary
Stroke limitation by
the workpiece end-
stop
Use an appropriate workpiece
end-stop
Coupling ring
works loose
Install a suitable workpiece end-
stop
Clamping force is
too high
Axial actuating
force is too high
Check machine setting and cor-
rect if necessary
Skilled special-
ist
Geometry devia-
tion on the work-
piece
Axial run-out error
on the adaptation
clamping device
Check axial run-out of the adapta-
tion clamping device and clean the
mating surfaces and locating taper
if necessary
Skilled special-
ist
Face run-out error
on the adaptation
clamping device
Check face run-out of the adapta-
tion clamping device and clean the
mating surfaces and locating taper
if necessary
Dirty end-stop area
Remove the workpiece end-stop
and clean the mating surfaces
Dirty coupling area
in the clamping el-
ement
Remove the clamping element,
clean the coupling area and the
clamping element
Dirty clamping ta-
per
Remove the clamping element
and clean the clamping taper
Geometry error on
the workpiece due
to incorrect type of
clamping element
Use a suitable clamping element