B-Top
Commissioning
66
Order h49 7144.907-333
figure must then be equal to or greater than the nominal total
stroke.
For the radial nominal total stroke, the values of radial clamp-
ing reserve and radial opening stroke must be added to-
gether [see »General inforamtion« chapter].
8.3 Tests
NOTE
Serious damage to, or destruction of, the machine
tool and the workpiece caused by damaged, in-
complete or incorrectly installed products!
Only install undamaged and complete products
properly.
If in doubt, contact the manufacturer.
Assure the following points before every installation and/or
before every time the products are put into service:
The products used are undamaged.
All fixing screws are present on the products, and are
tightened to the correct tightening torque.
Serrations and grooved profiles must not be excessively
rounded because this would prevent the friction coeffi-
cient from being achieved.
None of the edges and races are chipped or show any
signs of wear.
The speed set on the machine tool must not exceed the
maximum speed of the product. Always take the lowest
value of all maximum speeds for combined products in-
dicated.
Pay attention to the level of actuating force established
to enable the workpiece to be clamped with sufficient
clamping force.
Do not exceed the maximum actuating force indicated
on
the
product.
Always take the lowest value of all actuating forces indi-
cated for combined products.
All installation tools are removed from the machining
area.
Clamping device and workpiece are compatible - check
clamping diameter on a regular basis.
Conduct a clamping force measurement.
