9
6.0 Donning
Note:
Sewn terminations should be secure, complete, and not visibly damaged. No load indicators shall be deployed.
Damaged and other deteriorated and defective components must be immediately removed from service.
Fitting an Hailo Wind Systems Full Body Harness
Follow step from 1 to 8 for wearing harness.
Step 1:
Hold
the harness by the dorsal D-ring and shake to allow any tangled straps to fall into place.as shown in Fig. 1
Step 2:
Unbuckle chest, leg and waist straps. If the harness has a belt, unbuckle it too.
Step 3:
Slip the straps over the shoulders, so the back D-ring is located in the middle of the back between shoulder blades.
Step 4:
Connect the chest strap and position in the mid chest area, then tighten shoulder straps.
Step 5:
Pull harness up or down at the back so waist belt sits on the upper hip and connect belt buckles.
Step 6:
Pull the end of one leg strap between the legs and secure to the opposite end.
Repeat this step with the other leg. If harness has a belt, connect that after the leg straps.
Step 7:
After all the buckles have been connected, adjust so that the harness fits snug, but allows a full range of
movement.
Step 8:
Use the back D-ring or the front anchor point joined together by a connector as anchor point for fall arrest systems.
To locate the anchor points on the harness, check for the “A” marking near them.