15 rE
When power re-supplied, relay time adjustable.
Default =0, relay time is 10 seconds
0 min
0-15min
16 DE
Temperature-variation caused relay off-on process time set
0 min
0-15min
17 O5
Auto-adjustable function on and off 0=off, 1=on
0
0-1
18 OP
Preheat output displayed in advance setting
3h
0-3h
19 CO
Set preheat output value
20min
10min
10-120min
5-60min
20 Oh
Set only outside sensor‘s highest temperature
90
℃
194
℉
30-90
℃
85-194
℉
21 OL
Set only outside sensor‘s lowest temperature
0
℃
32
℉
0-10
℃
32-50
℉
NOTE:
(*) Only Auto-adjustable function on, parameter shows No.18, No.19.
(**) Only choose single outside sensor, parameter shows No. 20, No.21.
FLOOR TEMPERATURE EXAMINATION AND SETTING
Check the floor temperature: power on status, press “Mode” one time, LCD shows “
”, “XX.X
℃
” or “XX
℉
” shows the floor temperature. Single sensor setting is without this function.
Set the floor temperature: power off status: press “Mode” for 7 seconds, until LCD shows “SET XX.X
℃
” or “SET XX
℉
”, then press “Up” or “Down” to set the floor protection
temperature. Default Setting is 35
℃
[95
℉
].
LOW TEMPERATURE PROTECTION
When the low temperature protection is valid, thermostat turns off and the room temperature (or floor temperature) is lower than 5
℃
[41
℉
], the thermostat will auto start heating and
show “ ”, turn on the electric heating equipment, when the room temperature (or floor temperature) increases to 7
℃
[45
℉
], the thermostat will end output auto.
The on /off of the low temperature protection function, please refer to the “Parameter Setting Table”.
WIRING DIAGRAM
