Haier Super Match Series, Руководство по обслуживанию

Страница: 248 / 483

4
Loading of the battery
1
2
3
4
Parts and Functions
Indoor Unit
OUTLET
INLET
CONNECTING PIPING AND ELECTRICAL WIRING
DRAIN HOSE
Remote controller
4
Remove the battery cover;
Load the batteries as illustrated.
2 R-03 batteries, resetting key
(cylinder);
Be sure that the loading
is in line with the
" + "/"-";
Load the battery,then put on the cover again.
The distance between the signal transmission head and the rece-
iver hole should be within 7m without any obstacle as well.
Note:
Please be subject to the actual produce purchased the
above picture is just from your reference
Please be subject to the actual produce purchased the
above picture is just from your reference
Hint:
Remove the batteries in case won't be in use for a long period. If
there is any display after taking-out, just press reset key.
Inlet grille
Air Purifying Filter
Outlet
Emergency
Switch
(inside)
Outlet
indicator light
Vertical blade
Signal Receiver
POWER TIMER RUN
EMERGENCY AND TEST
SWITCH
Vertical blade
(adjust left and
right airflow,inside)
Horizontal flap
(adjust up and down airflow
Don’t adjust it manually)
Outdoor Unit
Signal Receiver
Push once to start operation,push once again
to stop it.
Operation is set to AUTO,air flow is set to
AUTO fan.
Use when remote controller is not available.
Upon receiving a signal, there is a receiving
sound.
1
2
3
When electronic-started type fluorescent lamp or change-over
type fluorescent lamp or wireless telephone is installed in the
room, the receiver is apt to be disturbed in receiving the signals,
so the distance to the indoor unit should be shorter.
Full display or unclear display during operation indicates the
batteries have been used up. Please change batteries.
If the remote controller can’t run normally during operation,please
remove the batteries and reload several minutes later.
EMERGENCY
SWITCH
ON/OFF button
EMERGENCY SWITCH
1. Mode display
2. Signal sending display
4. FAN SPEED display
5. LOCK display
6. TIMER OFF display
TIMER ON display
LO MED HI
7.TEMP display
16. LOCK button
Used to lock buttons and LCD display.
25. RESET button
When the remote controller
appears abnormal, use a sharp
pointed article to press this button
to reset the remote
22. HOUR button
Operation mode
AUTO FAN COOL DRY
Remote controller
HEAT
1
2
3
4
5
9
10
11
12
13
14
15
16
17
22
23
24
25
19
20
21
8
18
7
6
Control the lightening and extinguishing
of the indoor LED display board.
3. SWING display
8.
9. QUIET button
10. HEAT button
11. COOL button
12. AUTO button
13. FAN button
14. TIMER button
15. HEALTH button
17. LIGHT button
18. POWER ON/OFF button
19. DRY button
20. TEMP button
21. SWING button
23. EXTRA FUNCTION button
24.CANCEL/CONFIRM button
AUTO
Function: Setting and cancel to the
timer and other additional functions.
Display
circulated
Operation mode
Remote controller
QUITE POWER SLEEP
Supplemented
electrical
heating
HEALTH
Additional functions display
Healthy function is not available for some units.
Function: Air sending--- Healthy
airflow position1--- Healthy airflow
position 2 --- Restore the original flap
position --- Right & left air airflow---
A-B yard--- 10 and heating symbol
displayed simultaneously--- Sleeping---
Electrical heating--- Refresh air(
reserved
function)
--- Power--- Fahrenheit/Celsius
mode conversion
System configuration
Domestic air conditioner
247