Haier JC-398G, Руководство по обслуживанию

Страница: 6 / 26

５
Installation and Accessory Parts
Unpacking Your Wine cellar
1.Remove al l p ackaging material; this includes the foam bas e an d al l adh esive
tape holding the Wine cellar accessories inside and outside.
2.Inspect a nd r emove any remains of p acking, tape o r p rinted m aterials b efore
powering on the Wine cellar.
Adjusting Your Wine cellar
1.Your W ine cellar is d esigned for fr eestanding installation o nly. It s hould n ot b e
recessed or built-in.
2.Place the Wine cellar on a floor strong enough to support it fully loaded.
3.When m oving th e Wine cel lar, ne ver ti lt i t m ore t han a 4 5-degree an gle. This
could damage the compressor and the sealed system.
4.If the Wine cellar is tilted let it stand in an u pright position for at l east 24 hours
prior to plugging. This is to allow the refrigerant to settle.
·
Proper Air Circulation
z
To assure your Wine cellar works at the maximum efficiency it was designed
for, you should install it in a location where there is proper air circulation,
z
Plumbing and electrical connections.
z
The following are recommended clearances around the Wine cellar:
Sides…………..0.8”(20mm)
Top. ……………6.3”(630mm)
Back…………..4”(100mm)