Midway spinning
Push
Push
Proper
Proper
Outer cover of the spin tub
Inner cover of the spin tub
The laundries are slanting
Gland
No gland
1.
Put the laundries into the spin tub evenly and smoothly.
2.
Spin
(1) Put the gland in properly.
Please put in the gland properly even if the laundries quantity is small.
(2) Close the inner and outer cover of the spin tub.
(3) Spin for 1-2 minutes.
9
3.
Run the foam-removing spinning.
1
2
Set
the inlet
selector
handle on spin side and
fill
water
for
about
1 min.
Close the spin tub outer
cover
a
nd spin
for
about
1 - 2 min.
In case water
flows out
from wash tub side
due to too much inflow
,
please turn down
the water
tap a bit.
W
A
TER INLET
SELECT
O
R
W
ASH
SPIN
Not set
the switch to
DRAIN during washing
Wash timer
(To s
et to below 2 minutes,
first set to 6 minutes then
turn it back.).
Wash selector
(Strong current,
Standard current)
Drain selector
Spin timer
(To set to below 1 minute, first set to 2 minutes then turn it back. it can increase the service life of the timer).
WAT
ER INLET SEL
ECTOR
Page7
WASH
SPIN
1.Water-filling selector
1 Set the water inlet selector at the "WASH" side.
(Figure 1)
2 Set the water level adjusting lever to needed line.
2. Fill the water and add the dissolved washing
powder to make the water level reach the preset
position. (Figure 2)
Run washing program for some time to stir and
dissolve the powder completely.
3.Put in the laundries. If the water quantity is
insufficient, please add water.
4.Select the current.
Select the strength of the current according to
the laundries. (Figure 3)
5.Select the washing time
Select the washing time according to the laundries.
(Figure 4)
6.After washing, set the "WASH SELECTOR"
at "DRAIN". (Figure 5).
Wash
Figure 1
Figure 2
Figure 3
Figure 5
Figure 4
Washing sequence
8
4
3
2
1
5
12
9
6
3
15
O
F
F
OFF
STRONGSTRONG
ST
ANDARD
ST
ANDARD
OF
F
O
F
F
DRAINDRAIN
O
F
F
OF
F
1212
9
6
3
1515
O
F
F
O
F
F
O
F
F
O
F
F
DRAINDRAIN
STRONGSTRONG
ST
ANDARD
ST
ANDARD