Haier HWD100-BP14636, Руководство пользователя

Страница: 30 / 68

10- Installation
EN
30
Following connections are possible:
10.6.1 Drain hose to sink
▶
Hang the drain hose with the U-support over the
edge of a sink with adequate size (Fig. 10-6.1).
▶
Protect the U-support sufficiently against slip -
ping.
10.6.2 Drain hose to waste water connection
▶
The internal diameter of the stand pipe with
vent-hole must be minimum 40 mm.
▶
Put the drain hose for approx. 80 mm in the
wastewater pipe.
▶
Attach the U-support and secure it sufficiently
(Fig. 10-6.2).
CAUTION!
▶
The drain hose should not be submerged in water and should be securely fixed and
leak-free. If the drain hose is placed on the ground or if the pipe is at a height of less
than 80 cm, the washing machine will continuously drain while being filled (self-si -
phoning).
▶
Drain hose is not to be extended. If necessary contact after sales service.
10.6.3 Drain hose to sink connection
▶
The junction must lie above the siphon
▶
A spigot connection is usually closed by a pad (A).
That must be removed to prevent any disfunc-
tion (Fig. 10-6.3).
▶
Secure the drain hose with a clamp.
10.7 Fresh Water Connection
Make sure that the gaskets are inserted.
1. Connect the water inlet hose with the angled end
to the appliance (Fig. 10-7.1). Tighten the screw
joint by hand.
2. The other end connect to a water tap with a 3/4“
thread (Fig. 10-7.2).
10-7.2
10-7.1
10-6.2
10-6.1
10-6.3