Haier HW80-B14876, Руководство пользователя, Страница: 29 / 32

9-Installation
29
9.8 Electrical
●
Connection
Before each connection check if:
●
p
●
ower supp ly, socket and fusing are appropriate to
the rating plate.
the power plug and socket are strictly according.
●
Put the plug into the socket(Fig. 9-18).
9-18
WARNING!
Take care these parts are never to be crushed,kinked,or twisted.
Note: Self Clean
Ensure always that all connections(power supply,drain and fresh water hose)
are firm,dry and leack free!
If the supply cord is damaged,it must be replaced by the service agent (see
warranty card) in order to avoid a hazard.
After each installation or long periods of disuse,before first use and for regular
maintenance run programme Self Clean with no load and special machine
cleaner to remove possibly corruptive residues.
9.7 Fresh Water Connection
Connect the nut on the inlet hose to the connector on the
water valve(Fig.9-13).
Use the hose-set supplied with the appliance.
Old hose-sets should not be reused.
water inlet joint on the faucet, Make sure the screws is in
water inlet joint
lock pole
Slider
Water pipe
9-13
9-14
screw
9-15
9-16
9-17
a. Hold down the lower end of the lock pole,Then hold the
inlet pipe, press on the slider, and remove the water inlet
joint (Fig. 9-14).
c. Press the slider and insert the water pipe into the water
inlet joint, hang the water inlet joint with a lock pole and re-
lease the slider until a “snap” is heard(picture Fig.9-6 and
Fig.9-7).
(Fig. 9-15).