Haier HW70-IM12826TNZP, Руководство пользователя

Страница: 26 / 32

resh Water C
●
onnection
CAUTION!
The drain hose should not be submerged in water and should be securely xed and
leak-free. If the drain hose is placed on the ground or if the pipe is at a height of less
than 80 cm, the washing machine will continuously drain while being lled (self-si
-
phoning).
Drain hose is not to be extended. If necessary contact after sales service.
r 9.5.3 D ain hose to sink connection
The junction must lie above the siphon
A spigot connection is usually closed by a pad (A).
That must be removed to prevent any disfunc-
tion (Fig. 9-8).
Secure the drain hose with a clamp.
9-8
9.6 F
GB
9-Installation
26
Inlet Hose
water inlet joint on the faucet, Make sure the screws is in
●
place and tighten it (picture 3).
water inlet joint
lock pole
Slider
Water pipe
1.
2.
screw
3.
4. 5.
a. Hold down the lower end of the lock pole,Then hold the
inlet pipe, press on the slider, and remove the water
inlet joint (picture 2).
c. Press the slider and insert the water pipe into the water
inlet joint,hang the water inlet joint with a lock pole and
release the slider until a “snap” is heard (picture 4 and 5)
Connect the nut on the inlet hose to the connector on
the water valve (picture 1).
Following connections are possible:
9.5.1 Drain hose to sink
Hang the drain hose with the U-support over the
edge of a sink with adequate size (Fig. 9-6).
-
ping.
9.5.2 Drain hose to waste water connection
The internal diameter of the stand pipe with
vent-hole must be minimum 40 mm.
Put the drain hose for approx. 80 mm in the
wastewater pipe.
(Fig. 9-7).
9-6 9-7