Haier HW100-BP1439, Руководство пользователя

Страница: 17 / 64

EN
6-Daily use
17
6.12 After washing
1. At programme cycle end
EnD
is displayed.
2.
3. Remove laundry as soon as possible to go easy on it and to prevent more wrinkling.
4.
5. Unplug the power cord.
6.
Open the door to prevent formation of moisture and odours. Let it open while not used.
6.13 Activate or deactivate the buzzer
The acoustic signal can be deselected if necessary:
1.
Switch on the appliance.
2. Select the SPIN programme.
3. Press the “Steam “button and “Extra rinse” button at the same time for about 3 sec-
onds. “
bEEP OFF
” will be displayed and the buzzer will be deactivated.
For activating the buzzer press these two buttons at the same time again. “
bEEP On
”
will be displayed.
6.11 Interrupt - cancel wash programme
To interrupt a running programme press gently “Start/Pause“. The LED above the button
is fl ashing. Press it again to resume operation.
To cancel a running programme and all its individual settings
1. Press “Start/Pause” button to interrupt the running programme.
2.
3.
4. Select a new programme and start it.
Note: Door lock
▶
For safety reasons the door is locked partially during the washing cycle. It is only pos-
sible to open the door at the end of the programme or after the programme was can-
celled correctly (see description above).
▶
In case of high water level, high water temperature and during spinning it is not pos-
sible to open the door;
Loc
1-
is displayed
Note: Standby mode / energy-saving mode
The switched on appliance will go into standby-mode if it will not be activated within 2
minutes before starting the program or at the end of program. The display switsches
6.10 Start wash programme
Press “Start/Pause“ button (Fig. 6-7) to start. The
LED of the “Start/Pause“ button stops fl ashing and
lights up continuously
Appliance operates according to present settings.
Changes are only possible by cancelling the pro-
gramme.
6-7