TROUBLE SHOOTING
1. Normal Phenomena – Should not be considered as the trouble of the unit
a. Wine cooler does not operate
-
Check if the unit is plugged in.
-
Check if there is power at the power outlet by checking the circuit breaker.
-
Check if the ambient temperature is lower than the unit’s pre-set temperature.
(Preset lowest temperatue – 10 degree C; Preset highest temperature – 16 degree C)
b. Wine appears too warm
-
May be caused by frequent door openings.
-
Cooling time is too short to cool down the wine.
-
The door is not closed properly.
-
The temperature is set too high. Adjust to a lower temperature setting if necessary.
-
The ambient temperature is too high.
c. Wine temperature is too cold
-
The wine cooler temperature is set too low. Adjust to a higher temperature setting if necessary.
-
The ambient temperature is too low.
d. Wine cooler is runs too frequently
-
This may be normal to maintain constant temperature during high temperature and humid days.
-
Doors may have been opened frequently or for an extended period of time.
-
Check gasket of the door for proper seal. (re-adjust the door position if necessary. For details, please
refer to the “door replacement” diagram).
-
Check to see if doors are completely closed.
e. Moisture build up on interior or exterior of the wine cooler:
-
This is normal during high humidity period.
-
Prolonged or frequent door openings.
-
Check door gaskets for proper seal. (re-adjust the door position if necessary. For details, please refer
to the “door replacement” diagram).
f. Wine cooler door does not shut properly
-
Level the wine cooler.
-
Check for the blockages. For example, wine bottles, shelves ..etc..
Содержание HVW18 Service
