Outdoor Unit
Loading of the battery
Parts and Functions
Indoor Unit
Actual inlet grille may vary from the one shown in the
manual according to the product purchased
OUTLET
INLET
CONNECTING PIPING AND ELECTRICAL WIRING
DRAIN HOSE
Remote controller
Remove the battery cover;
Load the batteries as illustrated.
2 R-03 batteries, resetting key
(cylinder);
Be sure that the loading
is in line with the " + "/"-";
Load the battery,then put on the cover again.
Clock set
Press CLOCK button, "AM" or "PM" flashes.
Press or to set correct time. Each press
change quickly. After time setting is confirmed,press SET,
"AM "and "PM" stop flashing,while clock starts working.
or decrease 1min. If the button is kept pressed,time will
Inlet grille
Inlet
Air Purifying Filter
Outlet
Horizontal flap
Display board
(adjust up and do wn air flo w
Don't adjust it manually)
(adjust left and right air flow)
Vertical blade
Emergency
Switch
Anion generator
(inside)
will increase
The distance between the signal transmission head and the rece-
iver hole should be within 7m without any obstacle as well.
When electronic-started type fluorescent lamp or change-over
wireless telephone is installed in the
ver is apt to be disturbed in receiving the signals,
so the distance to the indoor unit should be shorter.
type fluorescent lamp or
room, the recei
Note:
Full display or unclear display during operation indicates the
ries have been used up.Please change batteries.
If the remote controller can't run normally during operation, please
reload several minutes later.
batte
remove the batteries and
Remove the batteries in case unit won't be in usage for a long period.
If there are any display after taking-out, just need to press reset key.
Hint:
POWER/SOFT
The following functions and related displays are not
20
available:
Operation mode
AUTO
FAN
COOL
DRY
Remote controller
HEAT
LOW
HI
MED
AUTO
If pressed, the other buttons
will be disabled. Press it once
again,lock will be cancelled.
30. LOCK button
19
28
30
1.CODE
Used to select CODE A or
B with a press, A or B will
be displayed on LCD.
Please select A without
special explanation.
POWER/SOFT
When the remote
RESET button
controller appears
abnormal, use a sharp
pointed article to press
this button to reset the
2.
Control the lightening and
the indoor
extinguishing of
LED display board.
remote controller normal.
3.LIGHT button
26
4. TIMER button
5. CLOCK button
6. HEALTH button
7. MODE button
8. HOUR button
9. SWING button
10. ON/OFF button
11. TIMER ON display
12. FAN SPEED display
13. LOCK display
14. SWING UP/DOWN display
15. SLEEP display
16. HEALTH display
17. Operation mode display
18.Singal sending display
19. POWER/SOFT display
20. Left/right air flow display
21. TEMP display
22. TIMER OFF display
23. CLOCK display
24. TEMP button
25. FAN button
26. HEALTH AIRFLOW button
27. SLEEP button
28. SET button
29. POWER/SOFT button
TEMP display
COOL
display
HEAT
display
HEALTH display
Dry
display
TIMER OFF display
TIMER ON display
SLEEP display
AUTO
display
Remote signal receiver
Display board
2
