SERVICE MANUL
Model No.HLTD500ACW
Issue
Rev.
- 8 -
2. The dryer must not be exhausted into any gas vent, chimney, wall, ceiling
attic, crawl or any concealed space of a building.
The dryer exhaust system
MUST be exhausted to the outdoors.
If the dryer is not exhausted outdoors,
some the laundry area. An accumulation of lint in any area of the home can
create a health and fire hazard.
3. Exceeding the length of duct pipe or number of elbows allowed in the
“Maximum Length” chart can cause an accumulation of lint in the exhaust
system. Plugging the system could create a fire hazard, as well as increase
drying times.
4. Do not screen the exhaust ends of the vent system. Lint can become caught in
the screen, increasing drying time. Use an approved vent hood to terminate the
duct outdoors, and seal all joints with duct tape.
5. All male duct pipe fittings must be installed downstream with the flow of air.
6. Exhaust duct must not be connected or secured with screws or other fastening devices which
extend into the interior of the duct.
7. Do not allow combustible material (clothing, draperies/curtains, paper, etc.) to come in contact
with exhaust system.
Explosion hazard:
Do not install the dryer where gasoline or other flammables are kept or stored. If the dryer
is installed in a garage, it must be a minimum of 18 inches (45.7cm) above the floor.
Failure to do so can result in death, explosion, fire or burns.
