English
SET UP INSTRUCTIONS
6
Tools and Parts Required for Installation:
Philips Head Screw Driver
•
Flat Head Screw Driver
•
Electric Drill and 1/8 inch drill bit
•
Stud finder (optional)
•
(6) Wood screws for mounting plywood
•
Plywood board; size 30 (h) by 24(w) inches or wood slats
•
Venting materials:
4 inch diameter metal exhaust rigid ducting and fittings or UL flexible metal
•
dryer vent hose, that should not exceed 6 feet.
2 additional hose clamps for ducting outside exhaust vent hose
•
Metal Elbows or outdoor vents as needed.
•
Location of Your Dryer
First find a suitable location where you can mount the dryer on the wall and still
have access to 120 Volt outlets and exterior venting.
Type:
Electric dryer
Rating: Please refer to the rating label regarding detailed information
Size:
26.97x24.8x16.73(inch)
Capacity: 2.6 cu.ft.
Weight: 52.9lbs(24kg)
Check dryer size and ensure a good location for the dryer installation on a
•
wall where you can mount the unit using wall studs or beams.
It is recommended to use a plywood board (30 by 24 inches) to mount the
•
dryer using the walls beams and studs as support, rather than just wood slats.
Make sure the dryer power cord can reach a 120 Volt outlet.
•
Make sure you can connect the exhaust vent to the outside or designated
•
dryer vent (in a laundry room).
The length of exhaust ducting should not exceed 6 feet.
•
Please read the additional ducting information and warnings in this manual.
•
16.73
”
26
.9
7
”
24.8
”
Vent to outside
Nearest 120 Volt
AC outlet