Haier DWL3025DWW, Руководство по обслуживанию

Страница: 15 / 27

-
15
-
Lower Spray Arm, Fine Filter, and Inlet
Cover
Check the holes in spray arm for bits of china,
seeds, and other foreign matter. Also check the
spray wash arms for rotation. If soil is present,
clean fine filter screen.
The lower spray wash arm can be removed by
gently lifting and rotating it counterclockwise.
The nut hub can be removed by rotating it
counterclockwise.
&DXWLRQ
Use care to avoid breaking the clip on
the hub when removing the main conduit from
hub.
1RWH
When installing the fine filter, make sure
the drain port of the filter is engaged with the
drain for the fine filter.
Top Spray Arm
Check the holes in spray wash arm for bits of
china, seeds, and other foreign matter. Also
check the spray wash arms for rotation.
To remove the top spray wash arm, remove the
upper rack (See
Middle Spray Arm ),
then remove
the screw and top spray wash arm.
Main
Conduit
The main conduit supplies water to the middle
and upper spray wash arms.
Removal and Replacement
1.
Pull upper rack all the way out.
2.
Push the tab on the outer slide cap in
and remove the slide cap.
3.
Remove the upper rack.
)LQH)LOWHU
'UDLQ3RUW
'UDLQ)RU
)LQH)LOWHU
/RZHU
6SUD\$UP
0RXWQJ6FUHZ
0DLQ&RQGXLW
1XW+XE
LQH)LOWU$VVHEO\
RY,QOHW
4. Release the bottom conduit tab.
5. Release 2 center conduit tabs and remove
the main conduit.
Fill Funnel
The top section of the fill funnel separates from
the main body. The fill funnel body is held in place
by a nut (located on the inside of the dishwasher).
Rotate the nut counterclockwise to remove the
main body. There is an O-ring seal between the
fi ll funnel and dishwasher tub. Make certain the
O-ring is fully seated when reinstalling.
&RDUVH)LOWHU
)ORDW'RPH
+XE
Main
Conduit
Tab
Nut
O-Ring
Service Manual
Model No: DWL Series
Issue
Rev.