Haier AU182XFERA, Руководство по установке

Страница: 26 / 65

Purging method: to use vacuum pump
In case of gas leakage, tighten
parts of pipe connection. If
leakage stops, then proceed
steps.
18
2 way valve
3 way valve
90
o
Service port
90
o
for 6 sec.
.Detach the charge hose from the service port, open
2-way valve and 3-way. Turn the valve rod
anticlockwise until hitting lightly.
Liquid stop valve
2 way valve
3 way valve
Gas stop valve
Gauge maifold(R410A)
Vacuum pump(R410A)
Open
Close
.Detach the service portis cap of 3-way valve, the
valve rod's cap for 2-way valve and 3-way valves, connect
the service port into the projection of charge hose (low)
for gaugemanifold. Then connect the projection of charge
hose (center) for gaugemanifold into vacuum pump.
.Open the handle at low in gaugemanifold, operate
vacuum pump. If the scale-moves of gause (low) reach
vacuum condition in a moment, check
again.
.Vacuumize for over 15min. And check the level gauge
which should read -0.1MPa (-76 cm Hg) at low pressure
side. After the completion of vacuumizing, close the
handle 'Lo' in the vacuum pump. Check the condition of
the scale and hold it for 1-2min. If the scale-moves back
in spite of tightening, make flaring work again, then
return to the beginning of
.
.Open the valve rod for the 2-way valve to and an angle
of anticlockwise 90 degree. After 6 seconds, close the 2-
way valve and make the inspection of gas leakge.
.No gas leakage?
If it does not stop gas leakage, discharge
whole refrigerants from the service port.
After flaring work again and vacuumize,
fill up prescribed refrigerant from the
gas cylinder.
.To prevent the gas leakage, turn the service ports cap,
the valve rodis cap for 2-way valve and 3-way's a little
more than the point where the torque increases suddenly.
CAUTION: If the refrigerant of the air conditioner leaks,
it is necessary to make all the refrigerant out. Vacuumize
first, then charge the liquid refrigerant into air conditioner
according to the amount marked on the name plate.
.Take the same steps from to for each ways
to ensure a completely vacuum for the whole system.
2 way valve
3 way valve
2 way valve
3 way valve
Valve rod cap
Valve rod cap
Service port cap
9.52mm
(3/8")
6.35mm
(1/4")
To indoor unit C
To indoor unit D
To indoor unit B
To indoor unit A
To indoor unit E
2 way valve
3 way valve
2 way valve
3 way valve
2 way valve
3 way valve
2 way valve
3 way valve
2 way valve
3 way valve
9.52mm
(3/8")
6.35mm
(1/4")
9.52mm
(3/8")
6.35mm
(1/4")
9.52mm
(3/8")
6.35mm
(1/4")
9.52mm
(3/8")
6.35mm
(1/4")