10
IIn
nsstta
alllla
attiio
on
n S
Stte
ep
pss a
an
nd
d S
Stta
arrtt--U
Up
p P
Prro
oc
ce
ed
du
urre
ess
P
Pllu
ug
g iin
n tth
he
e T
Trra
an
nssffo
orrm
me
err
A. Plug the transformer into an appropriate outlet.
(See Figure 15.)
B. Ensure that the outlet selected is NOT operated
by an on/off switch.
S
Se
ett U
Up
p tth
he
e C
Co
on
nttrro
olllle
err
A. Program the appliance controller (See Figure 16.
Also see
Setting and Using the Controller).
F
Fllu
ussh
h A
Ap
pp
plliia
an
nc
ce
e
A. Open a cold water tap and allow the appliance to
flush for 10 minutes or until approximately 35
gallons (132 L) of water have passed through the
appliance per NSF requirements.
B. Verify water flow by checking the WaterMizer
(flashing light.)
A
Ad
dd
d W
Wa
atte
err tto
o tth
he
e B
Brriin
ne
e T
Ta
an
nk
k
A. Remove any packaging or installation materials.
Do NOT remove the grid plate.
B. Add 1.5 gallons (5.7 litres) of water to the brine cabinet.
C. Ensure that the salt dosage is set as recommended for
the application. After the first regeneration, the appliance will
automatically refill the correct amount of water into the
brine tank.
D. Initiate a manual regeneration (See
Setting and Using
the Controller) and inspect for proper operation. Allow
the appliance to draw all the water out of the brine cabinet
until the air check sets.
E. Press the (R) button to advance to the Brine Refill
position (See
Setting and Using the Controller). Let
the tank fill with the proper amount of water. The
controller will then step the valve to the Home position.
Note
: This initial start up is the ONLY time you will add water to the brine tank. Do NOT add water at
any other time.
STEP 10
STEP 11
Figure 16: Controller
Figure 15: Plugging in Transformer
STEP 12
STEP 9
