Hagstrom KE-USB108, Руководство пользователя

Страница: 30 / 36

are debounced for that purpose. Logic drivers may be attached
to the inputs as well, provided they are an active low, logic level
signal. Refer to Appendix A on specifications for the timing of
logic signals.
NOTE: Never attach external power to the Inputs.
The KE-USB108 input headers are dual row headers with .100”
spaced pins. This format is suitable for many readily available
connectors on the market, including a typical IDE hard drive cable.
Since all the inputs are activated by the same logic Ground, this
Ground may be “daisy chained” to the Ground of all of the input
switches.
We also offer a breakout board for screw terminal access to the
KE-USB108 input headers (our part number IOX36). This interface
board attaches to the KE-USB108 headers through an IDE cable
(provided with the IOX36). See the Accessories page of this
manual for details on the IOX36.
Trackball Header:
The KE-USB108 features an Input Header for connection
to a Trackball. We offer a Trackball Cable (our part number
KE-TBH3) to connect the KE-USB108 trackball input to the trackball
itself. See the Accessories page of this manual for details on the
KE-TBH3.
Appendix E:
Joystick/Rotary Interface
Joystick:
The KE-USB108 features four 3 position interface connectors
which accept axis X, Y, Z and Rx signals from a potentiometer.
The Rx axis is labeled W on the KE-USB108.
Power is supplied to the potentiometer from the KE-USB108 for 5
volt operation only. This interface is compatible with most popular
potentiometer based joysticks.
Use our MTA100-3-12 cable to help
connect from the KE-USB108 to a
joystick potentiometer.
Use the diagram to the right to make
a connecting cable for a joystick
potentiometer.
The potentiometer resistance must be between 10K ohms and
1M ohms.
Gnd for Rx axis
Rx Input
5V = Power for Rx axis
(Rx labeled W on board)
Gnd for Z axis
Z Input
5V = Power for Z axis
Gnd for Y axis
Y Input
5V = Power for Y axis
Gnd for X axis
X Input
5V = Power for X axis
29 6
A1 = Y axis signal
5V = Power for Y axis
GND = Ground for Y axis
B1 = Y axis signal
A2 = X axis signal
5V = Power for X axis
GND = Ground for X axis
B2 = X axis signal
KE-USB108 - Trackball interface signal assignments.
NOTE: Do not supply power to the trackball interface connector.
NOTE: Do not supply any power into the Joystick interface connectors.