Haglof DP II, Руководство пользователя

Страница: 21 / 28

Version: 1.2 User Manual
Revised: 2015-03-16 15:47 DP II
© Haglöf Sweden AB 2013/Rev. 201503
|
17
Calibrating the inclinometer
The clinometer is calibrated on delivery but may need fine
adjustment according to below procedure:
1.
Go to ” SYSTEM MENU—SETTINGS—ANGLE—
CAL XYZ ”
2.
Place the computer terminal on a flat surface (a table)
with the display facing up. Press Enter when the text
”1:FLAT” appears.
3.
Rotate the terminal clockwise/counter clockwise half a
turn and press Enter when the text ”2:Turn Flat” appears.
4.
Turn the terminal upside down. The label on the back
should now be in front of you. Press Enter.
Calibrate the zero angle (0)
For calipers with factory assembled Gator Eyes. Go to ” SYS-
TEM MENU—SETTINGS—ANGLE—ZERO ”
1.
Put a visible mark on a wall, for example the height of
your chin.
2.
Walk 10m-30m from the wall and point with the Gator
Eyes, the point on the firm jaw on the mark with the
caliper held at the height of your chin. Press Enter to store
this 0-angle.
3.
Control measure this 0-angle.
Controlling the SmartScale
Controls of the SmartScale is made in the application used, or
in the menu SETTINGS—TESTS and Scale.
A calibration guide is used to control the measuring scale (art
no 16-102-1007). If you cannot access a calibration guide, use
the scale print.
Control that the displayed diameter value is consistent with
the value shown on the guide and/or the printed scale. Con-
trol at several points, 0 mm, 50 mm, 150 mm etc. For diver-
gences of >1mm, the SmartScale should be calibrated.
Maintenance
When cleaning the plastic housing, it is recommended to use
a dry or lightly moist piece of cotton cloth to remove dust and
dirt. Do not use a brush on the display, since this may scratch
the surface. Use a clean cloth and carefully wipe the display
clean. Do not use chemicals or cleansing liquids since this may
damage the housing. To clean the aluminum scale, use a clean
and dry cotton cloth and, if necessary, some mild detergent.
For paint stains and resin, a small amount of pure alcohol can
be used on the cloth to carefully wipe off the stain.