Hagie DTS 8 HI-TRACTOR, Руководство оператора, Страница: 66 / 121

FIG 5.77
speed
sensor
63
V.
OPERATING INFORMATION
PARAMETER SETTING
RPM................................................ 357 (fig. 5.75C)
MPH…………………………..(320/85R34 tire)- 78.2
(290/95R34 tire)-77.0
To change or re-enter the parameters, press
the desired button and hold in until the four “8”’s
are displayed. Release the button and the
parameter setting will appear. If you want to
increase the setting, press the RPM button. To
decrease, press the MPH button.
PROGRAMMING MPH - To program the MPH,
use the formula from figure 5.76. Example
(13.6R28 tires): 168 divided by the loaded circum-
ference times Torque Hub
®
reduction of 25.59
times number of speedometer ring pick-up sensors
on wheel motor (fig. 5.77) of 46 equals 7665 ;
10,135 divided into 600,000 equals parameter
setting of 78.2 (fig. 5.75D).
This parameter setting should be checked
when you receive your sprayer.
ADDITIONAL PARAMETERS – To access the
miscellaneous parameters screen (fig. 5.75E), hold
down both buttons at the same time until the
screen with four “8’s” appears.
Use the RPM button to scroll the parameter
settings (P3 = power-up display, P4 = signal track-
ing speed, P5 = input device). Use the MPH button
to change the setting of the displayed parameter
(either 0 or 1).
See the next page for more information.
The speed/tach unit is programmable with a
digital read-out indicating MPH or RPM. The
parameters have been factory set.
Turn the ignition key to the “ON” position. The
display will show “0000”, which indicates RPM.
Press the MPH button; the readout will display
“00.0” which indicates MPH.
To check the parameter settings, press the
desired button and hold until four “8”’s are shown,
then release (fig. 5.75B). The parameter setting will
be displayed for four seconds.
Speedometer/Tachometer
FIG 5.76
A = Torque-Hub
®
reduction
B = speedometer ring
pick-up
C = loaded circumfrence
Y = MPH parameter setting
C
168 x A x B
X
X
600,000
Y
FIG 5.75
A
E
C B
D