Hagie DTS 10, Руководство пользователя

Страница: 114 / 122

9-4
SECTION 9 –
MISCELLANEOUS
than the other without binding (when
adjusting tread setting).
5. Lubricate the slide path in which the leg
mount will travel along mainframe
(approximately 30”/76 cm).
NOTE: Refer to “Service - Lubrication”
provided in the Maintenance and
Storage Section elsewhere in this
manual for further information.
6. Place a suitable prop item (e.g. wood
block) beneath the air bag mounting
plate (before raising the machine) to pre-
vent the suspension from telescoping, as
shown in the following photo.
7. Raise the machine until the tires (on the
side being adjusted) are just touching the
ground.
To Adjust Tread Width Out
• Place a suitable prying tool beneath the
center of tire and pry out at the same
time, while simultaneously pushing out
at the top of the leg, as shown in the fol-
lowing photo.
• Carefully lower machine to the ground,
which in turn, will allow the leg to slide
outward.
• Repeat procedure until desired tread is
obtained.
• Observe tread width indicator (located
on each leg).
Rear Lock Nut
(Located on leg brace)
-Typical View
-Typical View
NOTICE
Empty solution tanks before raising the
machine.
-Typical View