hager WDI07 series, Руководство пользователя

Страница: 20 / 100

5 Information for electricians
5.1 Installation and electrical connection
DANGER!
Touching live parts in the installation environment can result in an electric shock.
An electric shock can lead to death.
Disconnect the connecting cables before working on the device and cover all live
parts in the area!
ç
Preparing installation
As a display and operating panel, the device
should be mounted in a place that is easily
accessible. The user habits are decisive when
determining the installation height. We recom-
mend an installation height from the display/
housing centre to the finished floor of approx.
1.65 m.
Prevent humidity and excessive dust at the
installation location. Do not install the device
near heat sources, such as radiators, stor-
age heaters or ovens.
The touch panel must be installed in a sepa-
rately available flush-mounted housing (see
accessories).
CAUTION!
Damage to the device if installed in a warped housing.
The device can be damaged.
When installing the housing in a wall, ensure that the wall opening is big enough
and the device can be inserted without tensions.
ç
Information concerning the installation of the
flush-mounted housing in solid and hollow
walls can be referred to in the instructions
enclosed.
To avoid EMC interference, do not install
network input cables parallel to mains ca-
bles.
Installing connector (RJ45) on the network cable (figure 11)
The flush-mounted housing is installed firmly
in the wall. The empty conduit with the network
cable is guided through an entry on the hous-
ing.
„
Insert the network cable through the metal
cap's earthing cover of the connector.
„
Strip the Ethernet strands of the network
cable, do not remove insulation.
„
Insert the strands into the plug-in connec-
tor (19) of the connector and bend up 90°.
Shorten any protruding strands.
When doing so, it is imperative to observe
the colour code EIA/TIA -568 A or B of the
system. This can be found in the documen-
tation of the installed network components
and routers. The Ethernet connection has
been connected to the device compatible
with wired networks in accordance with TIA/
EIA-568-A or B
„
Insert the plug-in connector into the connec-
tor (20) and snap it shut.
The plug-in connector is locked in place in
the connector.
„
Tighten the enclosed cable tie over the
earthing cover.
z
20