4200 SVR Exit Device
Installation Instructions
I-ED01626
Rev 1, Rev Date: 07/29/14
Page
4
of
6
2.
PREPARE DOOR
1)
Mark vertical and horizontal centerline (
℄
) for desired setup using the dimensions on page 1 of this instruction set.
2)
Tape drilling templates #T-ED01672 on the door, using the vertical and horizontal centerlines.
3)
Drill holes to sizes required for desired mount hardware for device, strikes, and latches.
4)
If using outside trim, prepare door using separate trim direction sheet provided with trim.
3.
Hardware Installation
1)
If using outside trim, mount trim per directions in trim box.
2)
Fix device with provided Sex Bolts and Through Bolts or Mounting Screws.
3)
Install end cap mounting bracket with provided Sex Bolts and Through Bolts or Mounting Screws.
-
Slide mounting bracket into push bar channel.
-
Level the device.
-
Mark mounting holes, and prepare the holes by drilling the appropriate sized holes based on mounting hardware
used.
-
Install mounting bracket with hardware that was prepped for.
Channel
Mark the two holes
