4200 SVR Exit Device
Installation Instructions
I-ED01626
Rev 1, Rev Date: 07/29/14
Page
6
of
6
7)
Install Top Rod
-
Screw the top rod onto the top latch bolt until the lower part of the rod
can clear the housing slide bar.
-
Unscrew the top rod from the top latch bolt while guiding the lower part
of the rod over the housing slide bar until the hole in the rod lines up
with the hole in the slide bar.
-
Insert the cotter key, but do NOT tighten the cotter key.
-
Test device to make sure the top rod locks and unlocks smoothly. Also
test the device to make sure the door opens and closes smoothly with
the top latch fully engaging.
-
If the device operates as desired, tighten the cotter key and drill and
install the top strike middle screw.
-
If the devise does NOT operate as desired, remove the cotter key and
adjust the rod by screwing it to raise or lower it as needed or adjust the
top strike depending on what is causing the improper operation. Repeat
steps C&D until it operates as desired.
8)
Install Rod Guides
-
Attached the rod guides to the rod, equidistant between the latches and device head. Drill the holes with __mm bit,
and mount with provided screws. The rod guide should not block movement of the rod.
9)
Apply Covers
-
Attach Head Assembly, End Cap, and Latch Covers with provided M4x8 screws.
2~5mm
