
Attach the support roller to the left side of the base.
Place the support roller (P) up next to the machine
base.
Align the 2 slots (O) in the base of the support roller with
the matching screw holes on the base of the machine.
Apply an M10 washer for each of 2 M10x25 hex head
bolts.
Loosely screw the hex head bolts into the aligned slot
(O) and holes.
Adjust the height of the support roller (P). Place a level
across the mouth of the vise and support roller. If a long
level in not available, use a straight bar or piece of
material then place a small level on top. Raise or lower
the support roller until level.
Secure the support roller (P) into place. Use a wrench
to tighten down the 2 hex head bolts.
Attach the bar stop to the vise.
Insert the thread end of the long rod (R) into the side of
the vise.
Turn the long rod clockwise until snug.
Use a wrench to turn the M12 hex nut (Q) on the long
rod (R) counter-clockwise, so that bar stop unit is
secure.
Attach the cover plate to machine stand.
Place plate (S) next to the hole at the base of the
machine stand.
Align the plate (S) holes the stand holes.
Use 4, M5X6 screws to secure into place.
Assemble the coolant tank
Insert the coolant pump (X) into the coolant tank (T).
Apply an M6 washer to each of 2 M6x20 screws (U).
Secure pump (X) to tank (T) with prepared screws (U).
Place the hose clamp (V) onto the 0.375 flow tube (W).
Connect the flow tube (W) to the hose connector (V).
Use a flat head screwdriver to tighten the hose clamp
(V).
11
10
9
O
P
Q
R
S
12
X
U
V
W
T
Page 8
Instruction Manual for CS-315D (S828)
03/12/2014