Press the red emergency button (E) when there are conditions of danger of malfunctions in
general, so as to stop machine operation immediately.
1
1
0
0
R
R
O
O
U
U
T
T
I
I
N
N
E
E
A
A
N
N
D
D
S
S
P
P
E
E
C
C
I
I
A
A
L
L
M
M
A
A
I
I
N
N
T
T
E
E
N
N
A
A
N
N
C
C
E
E
THE MAINTENANCE SCHEDULE AS BEEN DIVIDED INTO DAILY, WEEKLY, MONTHLY,
AND SIX-MONTHLY INTERVALS. NEGLECTING THE MACHINE MAINTENANCE WILL
RESULT IN PREMATURE WEAR AND POOR PERFORMANCE.
10.1 Daily Maintenance
Make a general cleaning by removing dust and shavings from the machine.
Top off the coolant.
Inspect the disk/saw blade for wear.
Raise the head into a high position to reduce stress on the return spring.
Check that the shields and emergency stops are in good working order.
10.2 Weekly Maintenance
Thoroughly clean the machine including the coolant tank.
Clean and grease the vice screw and sliding surfaces.
Clean the housing for disk/saw blade.
Sharpen the saw teeth.
10.3 Monthly Maintenance
Check that all screws on the motor, the pump, the vise jaws, and the guard are tight and
secure.
Check that the guard is free from defect.
Grease the hinge pin for the head assembly.
10.4 Six-Monthly Maintenance
Change the oil in the reduction unit using oil type DN SUPER GEAR 460 by IDEMITSU or
DAPHON
or equivalent oil, proceeding as follows:
Remove the connecting plug from the electric box and
unscrew the control handle.
Drain off the old oil from the drain hole (A)
Pour in new oil of to the mark (B), through the hole for the
control handle, keeping head in a horizontal position.
Reassemble all the parts.
Check continuity of the equipotential protection circuit.
10.5 Oils for Lubricating Coolant
Considering the vast range of products on the market, the user can choose the one most
suited to his own requirements, using as reference the type SHELL LUTEM OIL ECO.
THE MINIMUM PERCENTAGE OF OIL DILUTED IN WATER IS 8~10%.
10.6 Oil Disposal
Oil products must be disposed in a proper manner following local regulations. Please refer
to Machine disposal.
10.7 Special Maintenance
Special maintenance operations must be carried out by skilled personnel. However, we
advise contacting dealer and/or importer the term special maintenance also covers the
resetting of protection and safety equipment and devices.
A
B
Page 14
Instruction Manual for CS-315D (S828)
03/12/2014