Hafco BP-430, Инструкция по эксплуатации

Страница: 13 / 32

6. STEPS FOR THE TABLE PARALEEL ADJUSTMENT
1. Insert table pin into table groove. (see
Figure 1)
2. Use a ruler gauge and put it on the table.
Adjust the position of the table pin
(adjust the depth of the pin) and adjust
the parallel of the table by using the
feller gauge. The tolerance for the table
parallel is within 0.4mm.
3. When adjusting the table, the table edge
can be higher than the middle position
about 0.4mm. Edge cannot lower than
the middle part of the table. (see Figure
2 & 3)
NOTE: To insert the table pin deeper,
the middle part of the table will be
lower.
4. Follow above steps to finish the table
parallel adjustment.
TROUBLE SHOOTING:
In case if the table pin stuck because you
push it to deep, use a round bar
φ5mm~φ8mm and soft hammer to knock the
table pin out from inside of the table. Please
be aware of your fingers!
Table Pin
Figure 1
Figure 2
Figure 3
10
04/11/2019 Instructions Manual for BP-430 (W433) 13