Hafco BP-430, Инструкция по эксплуатации

Страница: 10 / 32

ADJUSTING 90 DEGREE TABLE STOP
1. Unplug power cord. Loosen the lock knobs (see
Figure 5) and tilting table left until it rests against
table stop bolt M8. (A, Fig. 6)
2. Use a protector placed on the table and against the
blade (Fig. 7) to see if the table is 90 degree to the
table. If it is not 90 degree, you can use micro-
adjust knob. Please lock the lock knob.
ASSEMBLING RIP FENCE
1. Setting the fixed base to the cast iron table with
two M6x20 hex head bolts and two M6 spring
washers. (Fig. 8)
2. Setting the square tube to the table with two
M6x16 hex socket bolts.
3. Setting the fence to the fence body. Place the
fence assembly on the fixed base and slide the
fence on its guides until it is the required
distance from the blade.
4. Check the scale, make sure the distance
between the edge of the miter slot and both the
front and rear of the rip fence. Adjust so both
distances are equal.
5. Lock the fence by pushing the locking handle.
CHANGING BLADES
1. Unplug power cord.
2. Remove the table insert and table pin.
3. Open upper and lower wheel cover.
4. Loosen the upper and lower blade guide system
and bearing.
5. Loosen quick change saw blade system lever on
rear of bandsaw.(see Figure 9)
6. Remove the blade and guide new blade through
table slot. Place blade in upper and lower ball
bearing guides system.
7. Replace blade in the MIDDLE of the upper and
lower wheel. If the blade is not in the right
position, you must relax the fixed handle and
adjust the tracking control knob.(see Figure 9)
8. Replace the table insert and table pin.
9. Adjust the blade tension and blade tracking if
the blade width is different.
Square tube
Fixed Base
Figure 8
Quick Change
Saw Blade
System Lever
Tracking
Control Knob
Figure 9
Fence
Figure 5
Figure 6
Figure 7
7
04/11/2019 Instructions Manual for BP-430 (W433) 10