Haes FUSION 0832-CPD-1431, Быстрый старт

Страница: 21 / 40

Fusion Quick Start Guide Approved Document Ref: UI-FBU-03 Issue 4.1
19
INSTALLATION
MAINS CONNECTIONS
CONNECTING THE BATTERIES
Do not connect the mains supply to the panel
until you are fully conversant with the layout and
features of the equipment.
A rating plate is fi tted in the bottom right hand
corner of the panel describing the nature of the
supply permitted.
The incoming mains supply should be brought
into the panel in the bottom right hand corner, via
the knockout provided.
A suitable cable gland must be used to secure
the outer sheath of the cable used. The earth
must
fi rst be connected to the primary earth stud
(peg) marked with a symbol, using the ring crimp provided.
Suf fi cient earth lead should be left to allow Live and Neutral connections to be accidentally pulled from
the terminal block while leaving the earth connection intact. Secondary earths may be connected to the
brass earthing block.
1 2 3 4
ON
+ +
- -
36V DC INPUT
T5A L250V 20X5MM
BATTERY
START
EMON 2 1 CAL
27V4 @ 20C
BATTERY
START
CAL B
1 2 3 4
IP
EM
+ +
- -
36V INPUT
INPUT FUSE 5A
T5A L250 Vac
5A 20mm LBC
L N -V -V +V +V
Batteries of even very small capacity are capable of delivering very high currents which can cause fi re or
injury, therefore battery connections should be done with caution.
The panel is supplied with battery leads already connected to the battery terminals on the power supply
module. These leads are coloured red for +ve and black for -ve.
2 x 12v batteries should be connected in series using the
white jumper lead provided. See diagram.
To optimise the service life of the batteries, the battery
charger output voltage varies with temperature.
N.B.
In the event of mains failure, the battery charger circuit will
protect the batteries from full discharge by disconnecting
them when they reach below 19v. When the mains supply
is restored the batteries will be automatically reconnected. 7.5
+
-
+
-
+
-
BATT
28V
OP1
28V
OP2
PSD
PSC
12V
COM
NO
+
--
+
--
+
+
--
BA
TT
28V OP1
28V OP1
BA
TTER
Y
FUSE
3 6 '
3 6 &
CN
O
12V
FA
U
L
(ENERG
F 7.5A
32VDC
7.5A
A
T
O (BROWN)
PSUFUSION 5A
INPUT
VOL
T
AG
INPUT
CURREN
+ve -ve
12v SLA Battery 12v SLA Battery
1 2 3 4
ON
+ + - -
36V DC INPUT
T5A L250V 20X5MM
BATTERY
START
EMON 2 1 CAL
OP1 LIMIT
OP2 LIMIT
VOLTAGE
ADJUST
27V4 @ 20C
BATTERY
START
CAL B
1 2 3 4 IP
EM
+ +
- -
36V INPUT
INPUT FUSE 5A
T5A L250 Vac
5A 20mm LBC
1 2 3 4
ON
-
3
BATTERY
START
EMON 2 1 CAL
BATTERY
START
CAL B
1 2 3 4
IP
EM
-
3
To power up the panel without a mains supply,
connect the batteries as shown above and
press the battery startup button on the power
supply module.