Haemonetics LN9000-110-EWC, Руководство по эксплуатации

Страница: 43 / 110

Describing the MCS+ Cabinet Components 2-13
P/N 85213-30, Manual revision: B
RETURN mode
! The YELLOW LIGHT indicates that the non-selected blood components
are being returned to the donor.
Note: If any of the DRAW mode lights are lit, the donor can promote blood flow
by clenching and relaxing the hand below the needle site.
When the RETURN yellow light is lit, the donor should not do this, because the
blood components in the bowl are being returned. The operator should instruct
the donor to observe the differences in the lights and act accordingly.
Figure 2-9, MCS+ left side panel
Anticoagulant
(AC) drip monitor
The AC drip monitor contains an optical sensor, used to detect the flow of AC
solution as it passes from the AC drip chamber into the AC tubing. If the AC drip
monitor detects a problem with the AC flow, the MCS+ pumps will stop. The
operator will receive an explanatory screen message, as well as an audible alarm.
! During PRIME and DRAW, it monitors the flow of AC solution being drawn
through the tubing by the AC pump.
!
During DRAW, the flow corresponds with the programmed AC ratio. The
AC drip monitor works in conjunction with the ACAD to ensure the flow
of AC solution to the donor-line tubing.
!
During RETURN, the AC drip monitor functions as a safety feature to en-
sure that no AC solution is passing into the donor-line tubing.
Caution: The lens of the optical sensor must be kept clean so that the AC drip
monitor can provide accurate readings.
1. Solution bag pole
2. AC drip monitor
3. Power entry module
4. Power cord
5. Flow indicator lights
6. Handle (one on each
side)
7. Bar-code reader
1.
2.
3.
4.
5.
7.
6.