6
5.52.541.01.01.09
DANGER!
The ambient temperature range must not be exceeded!
NOTICE!
If the units are not used as intended, safe operation is not guaranteed.
The operator alone is responsible for all personal injury and damage to property resulting from improper
use.
DANGER!
It’s only allowed to use the unit in the EX-classification which is named on the type plate; or in lower
classes.
2.5
Basic safety measures
Observe installation-, operation and maintenance instruction.
Take notice of caution notes at units and in the manual
Observe safety distances.
Ensure good visibility during operations
Use the equipment only for its intended purpose
The equipment is only intended for moving goods. Persons must not be moved under any circumstances.
Never load the equipment beyond the specified permissible load capacity.
Observe the relevant national accident prevention regulations.
Should the hoist be used outside of Germany, please pay attention to the national regulations that apply.
Building walls, ceilings, floors or constructions - on which the units are mounted or suspended - must be
checked by a structural engineer for sufficient stability.
After the unit has been standing for a longer period of time, visually inspect all components that are
important for its function and replace damaged components with new original spare parts.
Do not use a defective unit; listen for abnormal operating noises.
In case of malfunctions, stop the operation immediately and rectify the fault.
Report damage and defects immediately to a responsible person
When working with the unit, warn persons in the immediate vicinity.
Observe the provisions for load suspension equipment in accordance with the relevant national
regulations for the positive and non-positive slinging of loads.
The sling or load must be securely attached to the load hook and rest on the bottom of the hook.
The safety latches of hooks must be closed.
The housing must not be in contact with anything.
Stop lowering the load when the bottom block or the load is being set down or is prevented from being
lowered further.
The loose chain end may not be charged or locked.
The load chain must not be twisted.
Twisted chains must be aligned before attaching the load.
The correct alignment of the chain links can be seen from the weld seams.
The chain links must always be aligned in one direction.
Illustration 1
Do not bounce the load or hook against something.
NOTICE!
Pneumatic air motors are capable of operating at continuous duty up to 100% and 360 cycles per hour and
can be used in accordance with their device classification (mechanism class). The remaining service life of
the devices in accordance with mechanism group and usage (see calculation of remaining service life)
must be followed.
