HADEF 62/05 S, Инструкция по установке, эксплуатации и обслуживанию для установщика и пользователя

Страница: 22 / 25

22
5.52.420.00.01.09
14 Service
14.1 Load chain
Wear at the links is mainly due to insufficient maintenance of the chain.
To ensure optimal lubrication of the links, the chain must be lubricated at regular intervals, depending on
usage.

Lubricate the chain with oil that creeps.

Always lubricate the chain when it is not under load so that the oil can wet the links affected by wear. It is
not sufficient to lubricate the chain from the outside, as this will not ensure the formation of a lubricating
film within the links. The adjacent link points must always be lubricated to prevent excessive wear.

If the same lifting operations are carried out constantly, the switching area from a lifting to a lowering
movement must be given special attention.

Thoroughly effected lubrication of the chain will prolong the life of the chain by approx. 20 times,
compared to dry run with unlubricated chain.

Wash dirty chain with petroleum or a similar cleaner, under no circumstances heat the chain.

If there are environmental influences that foster wear, such as sand, a dry lubricant should be used, e.g.
graphite powder.

When
lubricating the chain’s condition of wear should be checked.
CAUTION!
Do not use grease for lubrication of load chain.
Without lubrication, manufacturer's warranty and/or liability will be void.
14.2 Pulleys
14.3 Load hook

Check bearings and pulleys yearly

Clean and lubricate the bearings of hooks and pulleys with grease

Slight bearings are maintenance free

When bearings resp. slight bearings are worn of, change the complete pulley
14.4 Hoist gear

Low maintenance.

Oil and grease life of the gear and of ball bearings is designed for the first safe operating period (S.W.P.)
of the chain hoist.

Shorter maintenance intervals for particularly difficult operating conditions, e.g. increased dust and
pollution loads or constant operation of the hoist with the highest load

Lubricant: synthetic, viscosity VG 220
Use Recommendation Interval
Load chain
oil for example: FUCHS RENOLIN PG 220
or special chain lubricant
Use NO grease!
0,2 l 3 month
Use Recommendation Interval
Pulleys
FUCHS
RENOLIN PG220
Acc. to demand 12 month
Use Recommendation Interval
Load hook
bearing
FUCHS
RENOLIN PG220
Acc. to demand 12 month