HADEF 29/06 EES, Инструкция по установке, эксплуатации и обслуживанию

Страница: 21 / 25

5.52.180.00.01.07
21
14 Service
Pos: 18.2.1.1 /1_HADEF/14-WARTUNG/Kettenzug/Lastkette/01.Lastkette - Schmierung @ 0\mod_1173362815667_52.docx @ 588 @ @ 1
14.1 Load chain
Wear at the links is mainly due to insufficient maintenance of the chain.
To ensure optimal lubrication of the links, the chain must be lubricated at regular intervals, depending on
usage.
ƒ
Lubricate the chain with a lubricant that creeps, e.g. automotive gear oil.
ƒ Always lubricate the chain when it is not under load so that the oil can wet the links affected by wear. It is
not sufficient to lubricate the chain from the outside, as this will not ensure the formation of a lubricating
film within the links. The adjacent link points must always be lubricated to prevent excessive wear.
ƒ
If the same lifting operations are carried out constantly, the switching area from a lifting to a lowering
movement must be given special attention.
ƒ
Thoroughly effected lubrication of the chain will prolong the life of the chain by approx. 20 times,
compared to dry run with unlubricated chain.
ƒ
Wash dirty chain with petroleum or a similar cleaner, under no circumstances heat the chain.
ƒ If there are environmental influences that foster wear, such as sand, a dry lubricant should be used, e.g.
graphite powder.
ƒ When lubricating the chain’s condition of wear should be checked.
Pos: 18.2.1.2 /1_HADEF/---ALLGEMEIN/Hinweise/Ketten/VORSICHT - Ketten: Kein Fett, ohne Schmierung keine Haftung @ 0\mod_1177481784104_52.docx @ 5349 @ @ 1
CAUTION!
Do not use grease for lubrication of load chain.
Without lubrication, manufacturer's warranty and/or liability will be void.
Pos: 18.2.1.3 /1_HADEF/14-WARTUNG/Kettenzug/Lastkette/01-1.Umlenkrollen-Schmierung @ 1\mod_1271680090245_52.docx @ 13447 @ @ 1
14.2 Pulleys
Pos: 18.2.2 /1_HADEF/14-WARTUNG/Kettenzug/Lasthaken/02.Lasthaken - Schmierung @ 0\mod_1173364066362_52.docx @ 594 @ @ 1
14.3 Load hook
ƒ Check bearings and pulleys yearly
ƒ Clean and lubricate the bearings of hooks and pulleys with grease
ƒ Slight bearings are maintenance free
ƒ
When bearings resp. slight bearings are worn of, change the complete pulley
Pos: 18.2.3.1 /1_HADEF/14-WARTUNG/Kettenzug/Getriebe/03.Getriebe - Schmierung 29/06E-Synchro @ 2\mod_1279549485810_52.docx @ 14876 @ @ 1
Use Recommendation Interval
Load chain
Gear oil for example: FUCHS RENOLIN PG
220 or special chain lubricant
Use
NO
grease!
0,2 l 3 month
Use Recommendation Interval
Pulleys
FUCHS
RENOLIT FEP2
Acc. to demand 12 month
Use Recommendation Interval
Load hook
bearing FUCHS
RENOLIT FEP2
Acc. to demand 12 month