HACA LEITERN 0529.74, Инструкция по эксплуатации, Страница: 42 / 64

Lorenz Hasenbach GmbH u. Co. KG · D-65517 Bad Camberg · Tel. 0049 6434 / 25-0 · www.haca.com
42
Lorenz Hasenbach GmbH u. Co. KG · D-65517 Bad Camberg · Tel. 0049 6434 / 25-0 · www.haca.com
Treat the fall protection runner in a manner fit for pur-
pose;it is there to save your life and protect your health.
1.3 Care / servicing / maintenance
Defective fall protection runners or those which have been involved in a fall
must be removed from use immediately and blocked by means of clear la-
belling. They may only be repaired by HACA or a HACA authorised dealer. An
expert must consent to the renewed use of the PPE. Handle the fall protec-
tion runner carefully, remove it from the fall arrest rail after use, store in a
dry room, however not near sources of heat. It must not be exposed to any
damaging influences which could impair its safe condition, e.g. acids, lyes,
soldering fluid, detergents etc. The fall protection runners may not be oiled
or greased. Dirt or mortar must be removed from them immediately, and
they can be cleaned with a damp cloth. Fall protection runners which have
gone wet should be allowed to dry naturally without the aid of heat sources.
2. Using the fall protection runner
The fall protection runner may fundamentally only be used in conjunction
with a safety harness in accordance with EN 361, in conjunction with an at-
tachment point labelled with an A.
The guided type fall arrester may only be used as intended. The climbing
path is only used to overcome differences in height. Working on the ladder
using the guided type fall arrester is prohibited! When working on the lad-
der, the user must additionally secure himself with a separate system, e.g.
a holding rope according to DIN 358
The fall protection runner may only be threaded in and out of the fall arrest
rail from a safe standing position of the user and at the designated re-
moval points. This can take place at the rail end, beginning or at a pivoting
removal point. The user must always secure himself against falls using a
fastener in accordance with EN 358 beforehand when detaching from the
closed fall protection system or when releasing the safety harness from the
fall protection runner.
The carabiner hook must be hooked directly –
without any intermedi-
ate links – into the front attachment point of the safety harness in accor-
dance with EN 361. The use of additional fasteners is prohibited!
Manipulation or extension of the connection between the safety harness
and the fall protection runner may lead to the mode of operation of the
runner failing.
This results in a life-threatening situation!