Warning
The screws must go into a wall stud (wood) or a wall anchor of the appropriate type for the wall. Screws
into drywall are not strong enough to mount the router.
Warning
Make sure that there are no concealed pipes and cables at the desired drilling location before drilling
any mounting holes. Damage to electricity cables, gas, water and sewage pipes can result in death or
material damage. Choose the installation location so that as few obstacles or electrical appliances as
possible disturb the connection.
Note
The screws and anchors are not delivered with the router.
There are two slots on the bottom of the device that can be used to fix it to the wall. You can see this in the following
figure:
To mount the router on a wall or another surface, follow these steps:
Procedure
Step 1. Align the two screws horizontally on a wall (or any other vertical surface) and install them 16.0 cm (6.3
inches) apart.
The screws should protrude 0.6 cm (0.25 inch) from the wall surface.
Warning
If you are installing the screws into drywall, use hollow-wall anchors (8 mm – 5/16 inch) to secure the
screws. If the screws are not properly anchored, the strain of the cables connected to the router's back
panel could pull the router from the wall.
Step 2. Hang the router on the screws.
3.3.3 Rack mounting
The M10-Smart router family can be installed in a 19” rack.
Teldat S.A.
3 Components and Power Supply
M10/M10L-Smart
11
