3. Install other expansion cards
4. Connect all signal cable, power cable, panel control cable and power supply unit.
5. Start the computer and complete the BIOS settings.
Key components of this motherboard are integrated circuit, and these components
will be easily damaged by electrostatic influence. So, before installing the
motherboard, you should always keep the following precautions in mind:
1. Hold the board by edges, don’t touch any components or plug and socket pins
2
．
Wear anti-static gloves/wrist strap while touching the integrated circuit components, such as
CPU, RAM, etc.
3
．
Put those unused or uninstalled components in static shielding bags or trays
4
．
Please first check the power switch is off before connecting the power plug
2.3 Install RAM
Board with one DDRIII slot, please pay attention to following remarks before installing the RAM
module:
1. First, please algin the notch of the memory bank with the notch on the socket and press the
memory bank slowly into the socket.
2. Please choose the proper memory bank that matches your motherboard
2.4 Jumper Settings
Please refer to following instructions to do jumper settings before installing your hardware
devices.
Remark:
How to identify the PIN1 of all jumpers and interfaces: Please observe the word mark
on the side of the plug socket, which will be a “1” or bold line or triangular symbol; And please
look at the back of PCB, each with a square shape will be the PIN 1; and all the jumpers’ PIN1
have a white arrow on the side.
2.4.1
CMOS Clear/Hold Jumper Setting
（
JCC
）
CMOS is powered by the onboard button cell. Clear CMOS will lead to permanent elimination
of previous system settings and back to the original system setting (factory default).
Steps:
（
1
）
Turn off the computer and disconnect the power supply
（
2
）
Use Jumper Cap JCC Pin1-2 short for 5~6 sec. Then restore the default setting
5
