Habasit PQ-01, Руководство по эксплуатации и обслуживанию

Страница: 23 / 34

Habasit Italiana S.p.A.
Via del Lavoro 50
I-31016
– Cordignano (TV)
Tel.: +39 0438 9113
Fax: +39 0438 912374
Use and maintenance manual
CQ-01
Author: FT Page 3 of 14
Edition: 06/2017 R. 0
Replaces:
0 Introduction
The joining spring clamp CQ-01 is a device for positioning of belt ends during the welding of thermoplastic
round belts (Polycord).
Its use is expected in combination with the welder W-01 specifically dedicated to the welding of thermoplastic
round belts (Polycord).
The joining spring clamp CQ-01 is suited for on-site installation or for medium/small mass production in a
workshop.
1 General information
1.1 Application
The joining spring clamp CQ-01 was specifically designed for a rapid and safe positioning of thermoplastic
round belts up to a diameter of 15 mm /
0,6 in ..
These operating instructions imply that all assembly, maintenance, and repair work, as
well as operation of the positioning device, be carried out by SKILLED/QUALIFIED
PERSONNEL or monitored by responsible specialists.
For reasons of scope, these instructions cannot cover all possible aspects of operation,
maintenance, or repair. The indications given herein refer to the use of the machines
according to their designated purpose by skilled personnel.
In case of doubt or if further detailed information is required, please consult the
manufacturer.
1.2 Important safety terms
Symbols WARNING and INDICATION were included in this manual.
These symbols indicate hazards or special instructions to be observed.
WARNING Serious injury and/or serious material damages may ensue if ignored.
INDICATION Indicates important technical information that may not be known to
even expert personnel.
1.2.1 Personnel safety
Never use the tool when tired or under the influence of drugs, alcohol or prescription medicine.
Always wear personal safety devices as well as protective gloves.
When the tool is not used, keep out of reach of children. Do not allow untrained personnel or personnel who
have not read these instructions use the tool.
1.2.2 Improper use
The joining spring clamp CQ-01 was exclusively designed for the applications described in this user manual.
An improper use and an application for different purposes than those described in the instructions are not
allowed.