10
96-0041 Rev U
July 2010
o
peraTion
1. To access IPS, press MDI/DNC, then PROGRM/CONVRS.
2. When the recorder is available, a message appears in red in the lower right
corner:
MANUAL
SETUP
FACE
DRILL
POCKET MILLING
ENGRAVING
VQC
CENTER DRILL
CENTER DEPTH
CENTER PECK
DRILL TOOL
DRILL DEPTH
DRILL PECK
TAP TOOL
TAP DEPTH
0
0
0
0.0000 in
0.0000 in
0.0000 in
0.0000 in
0.0000 in
WRK ZERO OFST
R PLANE
NUM OF HOLES
X CENTER PT
Y CENTER PT
54
DIAMETER
ANGLE
CENTER HOLE
0.0000 in
0.0000 in
0.0000 in
0.000 deg
0.2000 in
0
0
0
BOLT CIRCLE
BOLT LINE
SINGLE HOLE
Press <CYCLE START>
to run in MDI or <F4>
to record output to a
program.
MULTIPLE HOLES
3. Press F4 to access the IPS recorder menu. Choose menu option 1 or 2 to
continue, or option 3 to cancel and return to IPS. F4 can also be used to return
to IPS from any point within IPS recorder.
0.0000 in
PLANE
NUM OF HOLES
IAMETER
CENTER HOLE
0.0000 in
0.2000 in
0
0
0
Press <CYCLE
to run in MDI or
to record outpu
program.
IPS RECORDER
F4 CANCEL
1. ) Select / Create Program
2. ) Output to current program
3. ) Cancel
IPS Recorder Menu
IPS Recorder Menu
Menu Option 1: Select / Create Program
Select this menu option to choose an existing program in memory or to create
a new program into which the G-code will be inserted.
1. To create a new program, input the letter ‘O’ followed by the desired program
number and press the WRITE key. The new program is created, selected, and
displayed. Press the WRITE key once more to insert the IPS G-code into the
new program.
Содержание Toolroom Mill
Страница 1: ...96 0041 Rev U July 2010 2010 Haas Automation Inc Toolroom Mill Operator s Addendum ...
Страница 2: ......