![background image](http://html.mh-extra.com/html/haan/floor-sanitizer-ms-30/floor-sanitizer-ms-30_user-manual_575829020.webp)
pg 18 877-HAAN DIRECT / 877-422-6347
www.haanusa.com
Fig 26
Using Your STEAM SYSTEM II
CAUTION
!
i
DO NOT
overfill the water
tank. Use only 1 cupful of
the included Fill Cup when
adding water to the tank. The
tank capacity is a maximum
of 2 fill cups (900ml/30 oz.)
of water.
Fig 27
Using the Attachments:
(cont)
Using the STEaM SYSTEM II
to clean and sanitize
rough surfaces :
(Tile, Grout & Rough Surface Brush)
The Tile, Grout & Rough Surface Brush (Fig 26) slips
onto the end of the extension poles to clean and
sanitize tile, grout and other rough hard surfaces.
1) Be sure the unit is OFF, unplugged and cool.
2) Disconnect the Steam Head from the lower
extension pole. Do this by pushing in the small
orange button (Fig 27) that says PUSH on
the Steam Head and by pulling the pieces apart.
Be careful not to pinch your fingers between the
pieces as you disconnect them.
3) Once you have the Steam Head removed you
can attach the Tile, Grout & Rough Surface Brush
directly to the lower extension pole. Use the side
ridges and the internal indents to align the hole
in the brush attachment to the orange PUSH
button on the extension pole. Holding the button
down, slide the brush attachment over the button
and onto the lower extension pole until the
button pops into place (Fig 28).
4) Depending on prior use, you may need to add
water to the internal Water Tank (see instructions
for this on pg 11-12, steps 11-14).
Be careful not
to over-fill the tank.
6) Plug the MS-30 into a grounded plug and press
the ON/OFF switch to start the heat cycle. The
GREEN Power ON light and the ORANGE READY
Light will illuminate. It takes approximately 3-5
minutes for the STEAM SYSTEM II to heat up and
generate steam. The READY light will deactivate
once the unit is heated and ready to begin.
7) You are now ready to use the MS-30 with the
Tile, Grout & Rough Surface Brush.
Use it to clean and sanitize tile floors, tile shower
stalls, grout and other rough surfaces where dirt
collects and will be softened by the steam and
brushed away by the stiff bristles of the brush
(Fig 29).
8) When you have finished, follow the directions given
for cooling down the unit (step 6, page 15)
and if
storing the unit see directions on pg 14.
Fig 28
Orange
PUSH
button
Orange
PUSH
button
ridges
Fig 29