Assembling Your STEAM SYSTEM II
To make sure you are completely satisfied with the operation of your MS-30
STEAM SYSTEM II, be sure to follow the assembly and operating instructions
included in this manual. Read this manual thoroughly before assembling your unit.
Pay specific attention to the product description and familiarize yourself
with all the parts of your STEAM SYSTEM II. Locate and organize the parts
of the unit before assembling. No additional tools are needed to put the unit
together. It is quick and easy.
2
1
Look for the small orange button that
says PUSH on the handle of the unit.
Align one of the extension poles (with
the hole in the front) with the orange
button and slide it onto the end of the
handle until the orange PUSH button
snaps up into place in the hole. You
will notice the PUSH button is sloped
on the bottom to allow it to slide into
the pole easily. Be careful not to
pinch your fingers between the
pieces when pushing the two
together.
Align the second extension
pole in the same manner
and repeat the process by
snapping it into place. There
are ridges on the sides that
correspond to indents inside
to assist in sliding the pieces
together.
pg 8 877-HAAN DIRECT / 877-422-6347
www.haanusa.com
3
Finally, attach the
Floor /Countertop
Steam Head to the end of
two joined extension poles
by sliding the front of the
head onto the orange PUSH
button until it snaps into
place. Use the side ridges
and internal indents to
guide it into place.
To assemble the STEAM SYSTEM II
for use as a steam cleaning floor
sanitizer, follow these easy steps:
PUSH
PUSH
➟
Sloped for
ease
