Using the Attachments:
(cont)
on pg 11-12, steps 11-13).
Be careful not to
over-fill the tank.
3) Plug the product into a grounded plug and press
the ON/OFF switch to start the heat cycle. The
GREEN Power ON light and the ORANGE READY
Light will illuminate. It takes approximately 3-5
minutes for the STEAM SYSTEM II to heat up and
generate steam. The READY light will deactivate
once the unit is ready to begin.
4) To attach the tray, place the front of the steam
head under the tabs on the front of the tray and
press down. The tray is made to fit snuggly and
will snap easily into place (Fig 14).
5) Push and pull the Steam Head slowly
across your carpet to thoroughly steam clean
and sanitize each section (Fig. 15).
6) When you have finished using the unit, turn it
OFF, place it on the Floor Protector Mat and wait
until the unit cools down (approximately 5 minutes).
Remove the Carpet & Rug Tray by using your foot
to hold the rear tab and then while holding the
tray with your foot, lift the unit off the tray.
The Carpet & Rug Tray will snap OFF easily as it
is designed for this
No Touch
method of removal
(Fig 16).
7) Store the attachment in a cool, dry area with the
other attachments.
Helpful HAAN
®
Hint
:
Lifting Fresh Stains
While using the
HAAN
®
Complete with the
Carpet & Rug Tray will not lift all set-in stains from
your carpet, our patented Ultra-Microfiber Pads
may be used to act as a “blotter” for removing
most fresh, wet spills and stains.
To remove a stain, attach the Carpet & Rug Tray to the
Steam Head and heat the unit as described above.
Place the Steam Head over the stain and hold it in
place for a few seconds to allow the steam to
penetrate the area of the stain. Push and pull the
Steam Head slowly across the stained area to
work the steam into the stain.
www.haanusa.com 877-HAAN DIRECT / 877-422-6347
pg 15
Fig 14
Fig 15
Using Your Product
Fig 16
Front
Tabs
Foot Tab
!
i
CAUTION
The product emits steam at
212˚F to sanitize the area
of use. This means that
the steam head, Ultra-
MicroFiber Pads and
attachments get very hot
during use. Care should
be taken when using this
appliance and DO NOT touch
them during use except in
the approved manner as
outlined in this manual.
