H3C WX1804H-PWR, Быстрый старт

Страница: 11 / 15

2-10
The following are the required terminal settings:
•
Bits per second —9600.
•
Data bits —8.
•
Stop bits —1.
•
Parity —None.
•
Flow control —None.
Connecting Ethernet cables
Connecting an Ethernet copper port
1. Connect one end of the Ethernet cable to an Ethernet copper port on the device, and the other
end to an Ethernet port on the peer device.
2. After powering on the device, examine the LEDs for the Ethernet copper port.
For information about the LED description, see "Appendix B LEDs."
Connecting a fiber port
WARNING!
Disconnected optical fibers or connectors might emit invisible laser light. Do not stare into beams or
view directly with optical instruments when the switch is operating.
CAUTION:
•
To connect a fiber port by using an optical fiber, first install a transceiver module in the port and
then connect the optical fiber to the transceiver module.
•
Insert a dust cap into any open optical fiber connector and a dust plug into any open fiber port or
transceiver module port to protect them from contamination and ESD damage.
•
Never bend an optical fiber excessively. The bend radius of an optical fiber must be not less than
100 mm (3.94 in).
•
Keep the fiber end clean.
•
Make sure the Tx and Rx ports on a transceiver module are connected to the Rx and Tx ports on
the peer end, respectively.
Only the WX1840H access controller provides fiber ports.
No transceiver modules are provided with the device. Purchase transceiver modules yourself as
required. For transceiver module specifications, see "Appendix A Chassis views and technical
specifications."
The fiber ports on the device support only LC connectors.
To connect an optical fiber for a fiber port:
1. Remove the dust plug from the fiber port.
2. Pivot the bail latch of the transceiver module up so that it catches a knob on the top of the
transceiver module.
3. Holding both sides of the transceiver module, insert the transceiver module slowly into the port.
4. Identify the Rx and Tx ports on the transceiver module. Use the optical fiber to connect the Rx
port and Tx port on the transceiver module to the Tx port and Rx port on the peer end,
respectively.
5. Examine the port LEDs:
{
If the LED is on, a fiber link has been set up.