Command Manual – Getting Started
H3C VG Series Voice Gateways
Chapter 1 Fundamental Configuration Commands
1-17
Using the command
duplex
{
full
|
half
} first and then the command
speed
negotiation
, you can set the interface run in negotiation mode and start the process to
negotiate both speed and operating mode.
Related command:
speed,
display interfaces ethernet
.
Example
# Set 10/100Base-TX FE interface run in full duplex mode.
[VG-Ethernet0]duplex full
1.3.7 hub-enable
Syntax
hub-enable
undo hub-enable
View
System view
Parameter
None
Parameter
Use the
hub-enable
command to configure the VG to work in HUB mode. Use the
undo hub-enable
command to restore the default work mode of the VG.
By default, the VG works in the route mode.
Note:
This command applies on VG 10-40 and VG 10-41 only.
Example
# Configure the VG to work in HUB mode.
[VG] hub-enable
1.3.8 interface
Syntax
interface type number
undo interface type number
