H3C UniServer R2700 G3, Руководство пользователя

Страница: 93 / 226

7-10
Figure 7-13 Removing the power supply air baffle
2.
Install the access panel. For more information, see " Installing the access panel ."
3.
Rack-mount the server. For more information, see " Rack-mounting the server ."
4.
Connect the power cord. For more information, see " Connecting the power cord ."
5.
Power on the server. For more information, see " Powering on the server ."
Replacing a riser card and a PCIe module
WARNING!
To avoid bodily injury from hot surfaces, allow the server and its internal modules to cool before
touching them.
The replacement procedure is the same for riser cards on PCIe riser connector 1 and PCIe riser
connector 2. This procedure uses the riser card on PCIe riser connector 1 as an example.
To replace a riser card and a PCIe module:
1.
Power off the server. For more information, see " Powering off the server ."
2.
Remove the server from the rack. For more information, see " Removing the server from a rack ."
3.
Remove the access panel. For more information, see " Removing the access panel ."
4.
Disconnect cables that might hinder the replacement.
5.
Lift the riser card slowly out of the chassis, as shown in Figure 7-14 .